Installation Manual
MMI-20075112
2. Gently lift the transmitter straight up, and rotate the transmitter to the desired position.
You can rotate the transmitter to any of the eight positions, but a stop exists that will not allow a full
360° rotation.
Figure 3-13: Rotation of the transmitter head
3. Gently lower the transmitter onto the base, confirming that the transmitter is in a locked position.
4. Replace the clamp in its original position and tighten the cap screw. Torque to 28 in lbf (3.16 N m) to
30 in lbf (3.39 N m).
Figure 3-14: Re-attachment of the sensor clamp
Installation Manual
Mounting and sensor wiring
August 2020
19