Table of Contents
Advertisement
Figure 66. Removing the Jumbo PERC card (H745P MX)
NOTE:
The Jumbo PERC card controls the internal drives, and the storage sled drives mapped to the storage controller.
Next steps
1.
Install the Jumbo PERC card (H745P
Installing the Jumbo PERC card
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
NOTE:
Jumbo PERC card is supported only on dual-processor configuration.
Steps
1. Remove the connector cap on the I/O connector from the Jumbo PERC card.
2. Pull the blue pull tag to raise the lever on the Jumbo PERC card.
3. Align the Jumbo PERC card with the slots on the system board.
4. Press the Jumbo PERC card firmly until it is fully seated.
5. Close the lever on the Jumbo PERC card.
72
Installing and removing system components
MX).
Safety
instructions.
Before working inside your
system.
Advertisement
Table of Contents
