Table of Contents
Advertisement
Figure 30. Removing drive backplane
Next steps
1.
Replace the drive
backplane.
Installing drive backplane
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Remove all the drives.
Steps
1. Verify backplane connector pins are not bent and then connect the signal cable to the backplane.
2. Align the guide pins on the backplane with the guides on the sled.
3. Insert the backplane into the guides and lower the backplane firmly until it is fully seated.
NOTE:
To install the backplane, ensure the two pins on the backplane tab seat into the two slots on the system chassis.
38
Installing and removing system components
Safety instructions
Before working inside the
system.
Advertisement
Table of Contents
