Table of Contents
Advertisement
Figure 77. Removing the Mezzanine-B card
Next steps
1.
Install the Mezzanine
2. Follow the procedure listed in
Installing the Mezzanine card
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
NOTE:
Mezzanine B card is supported only on dual-processor configuration.
Steps
1. Align the connector on the Mezzanine card with the connector on the system board.
2. Place the Mezzanine card on the connector and press the blue touch point firmly until it is fully seated.
3. Using the Phillips #2 screwdriver, tighten the captive screws on the Mezzanine card.
card.
After working inside your
Safety
Instructions.
Before working inside your
system.
system.
Installing and removing system components
83
Advertisement
Table of Contents
