Table of Contents
Advertisement
Figure 67. Installing the Jumbo PERC card (H745P MX)
Next steps
1. Connect the cable on the Jumbo PERC card.
2. Follow the procedure listed in the
Optional IDSDM module
Removing the IDSDM module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air
shroud.
Steps
Holding the blue tag, lift the IDSDM card out of the system .
CAUTION:
To prevent damage to the IDSDM card, you must not tilt the card while lifting it from the system
board.
After working inside your
Safety
instructions.
Before working inside your
system.
system.
Installing and removing system components
73
Advertisement
Table of Contents
