Installing The Perc Card - Dell EMC PowerEdge R340 Installation And Service Manual

Figure 45. Removing the PERC card
Next steps
1. Replace the PERC card.

Installing the PERC card

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in the
3. Remove the expansion card
Steps
1. Connect the PERC cable to the PERC card.
2. Flip and insert the PERC card in the connector on the system board.
3. Press the tab on the blue release latch to disengage it from the slot on the chassis.
4. Rotate the blue release latch until it locks with the PERC card.
5. Secure the blue release latch with a screw.
Safety instructions.
Before working inside your
riser.
system.
Installing and removing system components 47