Table of Contents
Advertisement
Figure 70. Removing a MicroSD card
Next steps
1.
Replace the MicroSD
2. Follow the procedure listed in
Installing the MicroSD card
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
NOTE:
To use a MicroSD card with your system, ensure that the Internal SD Card Port is enabled in System Setup.
NOTE:
If reinstalling, ensure that you install the MicroSD cards into the same slots based on the labels you had marked on
the cards during removal.
Steps
1. Locate the MicroSD card connector on the IDSDM module. Orient the MicroSD card appropriately and insert the contact-pin
end of the card into the slot.
NOTE:
The slot is keyed to ensure correct insertion of the card.
2. Press the card into the card slot to lock it into place.
76
Installing and removing system components
cards.
After working inside your
Safety
Before working inside your
system.
instructions.
system.
Advertisement
Table of Contents
