Learning Devices; Learning Inputs - Pyronix Enforcer 32-WE Wireless Setup Manual

4 . L e a r n i n g D e v i c e s

4.1 Learning Inputs

This section shows how to learn any inputs on to the Enforcer 32-WE. Refer to page: 4 for a list of all
wireless input peripherals available.
It is recommended that all wireless inputs are learned
at the Enforcer 32-WE before final installation. This
makes the learning procedure much quicker.
A maximum of 32 x wireless inputs may be learned.
Once 'Learning' has been completed, the position of
the input in a property must be tested for signal
strength before it is actually 'fixed' into place. See
page 10 when analysing the signal strength.
Before learning each input, check that the battery is
present and inserted correctly. To enable the battery
please remove the plastic strip. The LEDs will start
flashing.
Follow the instructions on the right to start learning
the inputs.
An input that is learnt correctly will flash the GREEN
LED briefly and 'Input Learnt' will be displayed on the
Enforcer 32-WE display. Both of these instances need
to occur to indicate a successful learn.
Once learning has completed, each input needs to be
given an input type (Final Exit, Intruder,etc.) see the
main programming manual RINS1549 for more
information. The function is called 'CHANGE INPUTS'.
If the Engineer's menu is exited before an input type is
assigned to a learnt input, an error mismatch fault will
be displayed.
Input and Sensors
MC1SHOCK-WE MC2-WE MC1MINI-WE
Detectors
KX12DT-WE KX10DTP-WE
Enforcer 32-WE Wireless Setup Manual
SMOKE-WE
KX12DQ-WE KX10DP-WE KX15DC-WE
Learning Procedure.
CO-WE W L-WE
KX25LR-WE
Page: 6