Table of Contents
Advertisement
7.2.3 Align supporting plate (PICTURE 7 NO. 76/5) on the gasket side of bar profile by moving forth and back
7.2.4 Clench the profile by rotating the clamp handle
NOTE: In order to have a correct measurement and cut, imaginary lines passing through A and B should
be perpendicular to each other as shown in PICTURE 7
7.2.5 After aligning the profile with the plate, place the bolt, which is on the scaled measurement section (PICTURE 7
NO: 76) on to the bolt, which is provided with a preset value on setsquare (PICTURE 7, NO. 82). Then, squeeze
the nuts by using a wrench and tighten the mold.
NOTE: By using the scales on the measurement (PICTURE 7 NO 76/2), height of the bolt can be adjusted
(PICTURE 7 NO. 76), and 8 different bar profiles are able to be cut at single mold.
7.2.6 Adjust the cutting length of the bead using the measuring tape and bead support plate.(PICTURE 7)
PICTURE - 7
37
Advertisement
Table of Contents
