Assembling Basic Fixture - ETC Source Four Assembly Manual

Assembling basic fixture

1: Follow instructions under
2: Follow instructions under
3: Follow instructions under
4: Assemble Lens Tubes following the instructions for your applicable lens degree application.
5: Insert lens tube assembly (8-16) fully into the front barrel assembly (6-7). Align the mounting hole
with the slot and secure with knob (17). See
6: Install reflector housing (2-5) onto front barrel assembly (6-7) and align the two mounting holes.
Secure with screw (19) on top, and knob (17) on bottom. Tighten both securely. See
page 3
.
7: Install the lamp socket assembly (1) to the reflector housing (2-5) and secure with brass knurled
screw on rear of lamp socket assembly.
8: Release the gel retaining clip by pushing it sideways while gently pulling backwards.
9: Insert the color frame.
10: Lock the clip by pushing sideways while gently pushing it forward.
4
Assembling lamp socket
Reflector Housing Assembly
Shuttle Barrel Assembly
Figure 1
page 6
on .
page 9
on .
page 12
on .
page 3
on .
Source Four Assembly Guide
Figure 1
on