Removing Reflector; Installing Reflector - ETC Source Four Assembly Manual

Removing reflector

Tools Required:
• Minimally padded work surface (cardboard, carpet, or rubber mat recommended)
WARNING:
1: Place the reflector housing face down on your work surface so that the concave reflector surface
points downward.
2: Loosen the clutch and rotate the yoke so that it is perpendicular to the housing at roughly a 90°
angle. Tighten the clutch.
3: Using the yoke as your handle, raise the housing assembly off of the work surface a few inches
and then firmly tap the housing on the work surface. This should force the reflector out of its
clips.
4: Carefully lift the housing to see if the reflector is released. If it is not, repeat step 3 with slightly
more force.

Installing reflector

Note:
1: Place the reflector housing casting (1-2) on a flat work surface with the large opening facing up.
2: Install the reflector support spring (4) in the circular opening at the base of the casting.
3: Insert the reflector (9) at an angle, under any three adjacent legs of the reflector's clips.
4: Gently press down on the opposite side of the reflector until it snaps into place under the
remaining clips.
Note:
10
This procedure may crack or break the reflector. Always wear gloves, safety
glasses, and a dust mask when performing this procedure.
The following assumes all four reflector retainer clips (2) have already been riveted to
the reflector housing casting (1) and the gate bushings (3) installed on the retainer
clips. See Figure 8.
Step 3
If the reflector does not snap in, turn the casting over. Gently pull on the side of the
reflector that has not snapped in until the rest of the reflector slides into place.
Under three
adjacent clips
Step 4
Source Four Assembly Guide