File Operations - ETC Echo Integration Interface Installation Manual

ETC Installation Guide
Integration Interface
Press the
until your desired setting is displayed. Press
Address or press the
Syslog Address
Configure the IP address to receive Syslog event messages. This defaults
to 10.101.50.60. Change the default IP address to match a logging server
on the Integration Network. Navigate to Syslog Address found in the
Logging Options menu. The first octet of the IP address is selected for
edit.
Use the
selection. Press the
changing the Syslog IP Address.

File Operations

Restore Defaults
To restore the Integration Interface to its factory defaults, returning the
unit to Automatic IP addressing mode, the UDP Port number to 04703,
clear all Subscribers, reset to Subscribers Only, and Syslog IP Address to
10.101.50.60. Use the navigation buttons to navigate and select "Restore
Defaults" from the menu. A message will prompt confirmation of the
Restore Defaults action. Select "Ok". The unit will reboot.
Update Firmware
1.
Note:
formatted to FAT32. SDXC is not compatible.
2.
3.
4.
5.
Integration Interface
button to toggle the setting between Enabled and Disabled
button to exit the menu.
and buttons to change the value, and press
button to exit the menu. A reboot is required after
To update the Integration Interface firmware, you must first
prepare a compatible microSD card with the firmware update file.
The firmware update file, labeled eeb_fw.efw, must reside on the
root of the media.
Compatible cards include SDHC microSD media up to 32GB,
Insert the compatible microSD media into the card slot receptacle
on the bottom of the Integration Interface.
Use the navigation buttons to navigate and select "Update
Firmware" from the menu. A message will prompt, "Insert Media
and do not remove until complete. Reboot Now."
ü
Press the (enter) button to begin the firmware update process.
The unit will update and reboot when the process is complete.
Use the navigation buttons to navigate to the "About" menu to
confirm the new installed firmware version.
to navigate to Syslog
Page 7 of 8
to set the
ETC