Table of Contents
Advertisement
ETC Installation Guide
Integration Interface
Supported UDP String Commands
Note:
below, please note the following:
•
•
•
•
•
•
Set Commands
E$pst act: spc_num(1-16), pst_num(1-64), time{EOM}
•
E$off: spc_num(1-16), time{EOM}
E$seq act: spc_num(1-16), seq_num(1-4){EOM}]
E$seq dact: spc_num(1-16), seq_num(1-4){EOM}
E$zone int: spc_num(1-16), zn_num(1-16), level(0-255), time{EOM}
Get Commands
E$pst get: spc_num(1-16){EOM}
E$off get: spc_num(1-16){EOM}
E$seq get: spc_num(1-16){EOM}
E$sync get: spc_num(0-16){EOM}
•
E$zone int get: spc_num(1-16){EOM}
Help Command
E$help{EOM}
•
Integration Interface
When reviewing the supported commands and responses
All command strings must start with E$, and all responses start
with E>
The End of Message {EOM} character by default is a carriage
return (shown as CR). Other options are available, review the
Subscriptions
menu for details
Parameters listed with ( ) in the sample commands display the
ranges that are compatible for the command
Level values are set on a 0-255 scale
Timing for Echo devices are communicated in decimal second
values. The accepted range is 0-25.4 seconds. Any numeric
value outside of that range will direct output products to use
internal default timings.
White space must separate individual command parameters.
For example E$pst act: 2, 12, 3.5{EOM}
A sync command for space 0 means all spaces.
Sending this command prompts the interface to return a list of
available commands to the requesting IP address and UDP Port.
Page 8 of 8
ETC
Advertisement
Table of Contents
