ETC Echo Echoflex Interface How To Configure

How Do I Configure the Echo Echoflex Interface?

Question
The Echo Echoflex Interface (EEI) has a lot of buttons and options, how do I go about setting it up and making sure it
works?
Answer
As explained in another article,
communication between Echo and Echoflex systems. While the
how to set up this device, below is a quick breakdown of the main setup and control options.

Steps/Controls

Configure the Echo Side

1. Assign Echo space via dial
2. Program which presets/zones the inputs/outputs talk to
a. Press and hold 'RECORD/PROGRAM' button for 3 seconds to enter program mode
b. Tap 'SELECT' button to navigate to desired input/output
c. Output Status LEDs will indicate preset/zone number for the selected input/output
d. Tap 'ON' and 'OFF' buttons to increase preset or zone number
e. Tap 'RECORD/PROGRAM' button to save changes and exit program mode

Configure the Echoflex Side

1. Link inputs (learn EEI to Echoflex input devices [stations/sensors])
a. Tap 'SELECT' button to choose desired input
b. Tap 'LEARN/TEACH' button on EEI to put the EEI in LEARN mode
https://support.etcconnect.com/ETC/Architectural/Aero_and_EchoFlex/Aero_and_Echoflex_Gateways_and_Interfaces/How_...
What Does the Echo Echoflex Interface Do?, the heart of this device is to set up
installation guide goes into complete detail regarding
Updated: Fri, 17 Sep 2021 16:17:12 GMT
Powered by
1