Table of Contents
Advertisement
ETC Installation Guide
Integration Interface
Reset Power
Using a ballpoint pen, press the [Reset] button to reset the Integration
Interface.
Menu
When the Integration Interface is connected to the bus, its connection
status displays as "E: " on the bottom of the display when in the main
menu.
About
The "About" menu provides read-only information regarding the
currently installed software on the Integration Interface. Pressing the
(enter) button navigates to the next screen, then returns to the main
menu.
Setup
IP Settings
Configure the network interface for the Integration Interface from the IP
Settings menu.
Automatic Mode
When Automatic IP mode is selected, all other IP address fields are
disabled. In "Automatic" IP mode, the Integration Interface will receive an
IP Address when its Ethernet interface is connected to a network with a
DHCP Server. A reboot is required after changing the IP address mode.
Manual Mode
When Manual IP mode is selected, the following settings are
configurable:
•
•
•
Use the
to set each octet of the selection. A reboot is required after changing the
IP address.
Integration Interface
IP Address: by default, the address is 10.101.19.201
Subnet: by default, the subnet mask is 255.255.0.0.
Gateway: by default, this is blank. A gateway address is only
required when the Integration Interface is used on a routed
network. In this case, this address should match the IP Address of
the router or gateway. When not used on a routed network, leave
this setting at its default.
button to select an option, and the
and
Page 5 of 8
navigation buttons
ETC
Advertisement
Table of Contents
Need help?
Do you have a question about the Echo Integration Interface and is the answer not in the manual?