Table of Contents
Advertisement
Step 6
Note: The Shape Air Ring has a blue
alignment mark . The blue alignment
mark will line up with the yellow dot
located on the Atomizer Body and
the small yellow line located on the
Turbine.
marks will have to be in line when
assembling.
Step 7
Note: Two (2) locating pins are
mounted on the back of the Shape
Air Ring to insure proper alignment.
Step 8
Insert the Bell Cup/ Combo Wrench
(RPM-419) across the flats located
on the Turbine. Remove the Bell
Cup by hand.
When reassembling the Bell Cup
hand tighten is sufficient.
LN-9282-14
DISASSEMBLY PROCEDURES
(30mm Bell Cup and Shape Air Ring)
Yellow Dot
Yellow Line
Blue Line
All three (3) alignment
Bell Cup
Aerobell 268 - Maintenance
49
Advertisement
Table of Contents
