Table of Contents
Advertisement
AIR FILTRATION REQUIREMENTS
Ransburg Filter
Model No.
HAF-503
HAF-508
RPM-418
C A U T I O N
!
† Air must be properly filtered to ensure
extended turbine life and to prevent contam-
ination of the paint finish. Air which is not
adequately filtered will foul the turbine air
bearings and cause turbine failure. The cor-
rect type filters musts be used in an Aerobell
268 system. The filter elements must be re-
placed regular schedule to assure clean air.
† It is the user's responsibility to ensure
clean air at all times. Turbine failure result-
ing form contaminated air will not be cov-
ered under warranty. If other filters are incor-
porated in the system, the filters to be used
must have filtering capacities equal or better
than those shown in "Air Filtration Require-
ments Charts."
† The user must ensure the bearing air
supply is not inadvertently turned off while
the Aerobell 268 air motor is turning. This
will cause air bearing failure.
LN-9282-14
Description / Specifications
Pre-filter, removes coarse amounts of oil, moisture
and dirt. Used upstream of HAF-508 pre-filter (used in
systems with poor air quality.
Pre-filter, coalescing type, 136 SCFM, 98.5% efficien-
cy particulate removal .3 to .6 micron, max. aerosol
passed 1.0 micron, max. solid passed .4 micron (de-
pendent upon SCFM requirement per applicator, one
HAF-508 can be used with up to three applicators.
Bearing air filter, coalescing type,19 SCFM, 99.995%
efficiency particulate removal .3 to .6 micron, max.
passed .6 micron max. solid passed .2 micron (one
per Applicator)
Aerobell 268 - Installation
HAF-15 Element One
HAF-38 Elements, Carton of 4
RPM-33 Elements, Carton of 8
NOTE
† Each applicator must have its own filter
for bearing air. Recommended: RPM-418
or equivalent.
Replacement
Element Part No.
24
Advertisement
Table of Contents
