Table of Contents
Advertisement
HIGH VOLTAGE CABLE
ASSEMBLIES
General Instructions
1. When routing cable, ensure that no chaffing,
binding, or pulling on the cable will occur. Maintain
at least a 4-inch (100mm) bend radius. When
possible, sleeve cable with the appropriate sized
tubing for external cable protection. Torsion stress
should be minimized.
2. Considerations should be taken when routing
cables next to other cabling and fluid tubing. Be
cognizant of the placement of such cable near
control wires and fluid lines. Follow NEC or EN
standard wiring standards where applicable.
Separation of AC, control wiring, and fluid tubing
is advisable.
3. To ensure that all cable connections are clean
and free of foreign materials, wipe with Naphtha.
This also applies to the cascade, splitter, and
applicator connectors.
C A U T I O N
!
† Do not use any di-electric grease or oil
on any of the cable connections or on the ca-
bles them self. Damage to cables will occur.
4. Ensure that no conductive sponges are used
in any connector!
5. A13659-XX cables are not to be modified in
the field. To do so will void any and all warranties
that may exist.
HIGH VOLTAGE CABLE
CONFIGURATIONS
A13659-XX is a resin core conductor cable with a
polyethylene jacket and an exterior Nylon sleeve.
It comes pre-assembled with banana jacks at
each end.
LN-9282-14
Aerobell 268 - Installation
AEROBELL 268 HIGH
VOLTAGE CONNECT AT
ATOMIZER END
Installation of A13659-XX Cable
Insert resistor (Shipped separately with Applicator)
A13382-00 into the applicator end of the cable.
APPLICATOR END
APPLICATOR END
Make sure the contact spring is outward as shown
below
Insert the high voltage connector on the cable end
into the applicator part marked with "HV". Tighten
the connector in place.
CASCADE END
CASCADE END
Contact Spring
HV Connector
A13382
A13659
30
Advertisement
Table of Contents
