Table of Contents
Advertisement
Aerobell 268 - Installation
AEROBELL 268
CASCADE CONNECTION
Insert the cable end of the A13659-XX cable into
the external cascade as shown.
AEROBELL 268
BEARING AIR FEEDBACK
If the atomizer is used in open loop control, you do
not need to connect any fittings to return bearing
air back to the controller.
If using a controller for speed, use the fittings pro-
vided to send an air signal back to the controller.
These fittings must be non-metalic. Reference
minimum bearing air pressure at the applicator
is 80 psi. (5.5 bars).
31
LN-9282-14
Advertisement
Table of Contents
