5 - 3 - 5
(2) When fitting the cable on the sensor lever, define the direction
(3) Cautiones when installing the Engine accelerator sensor
by pulling the cable parallelly to the direction of lever stroke so
that an imbalanced load may not be imposed on the sensor
shaft.
(See the following illustration.)
(hereinafter termed the sensor).
• Never attempt to disassemble the sensor.
Do not drop the sensor or do not shock it.
Each above thing may lead malfunction and failure.
• The sensor is not integral waterproof type.
Therefore, when installing it, pay attention to avoid the direct
projection of vehicle washing water, tire splash etc.
• The usable range of temperature is -30~80°C. Use it in the
said range.
• Install the sensor in the position which can apply lubrication.
• Avoid such places where there is risk of receiving falling
matters or stones that give impact.
• Install the sensor where there is no possibility of exposing
dust, oil mist, humidity, chemical product or vibration.
If it is impossible to find such place, protect it with a cover.
• Install the wire harness certainly so that it may not twist or
not bend extremely.
• For fitting and clipping the harness wires,refer to the
COMMON manual.
• If the length of the sub-harness wire is too short, try to abtain
the same kind of the harness wire for extension.
KK-XZU215C