How To Install Engine Accelerator For Body Or Equipment - Hino Motors 300 Series Mounting Manual

3) HOW TO INSTALL ENGINE ACCELERATOR FOR BODY OR
EQUIPMENT
KK-XZU215C
(1) Be sure to provide the body controller with the full speed
stopper for controlling the stroke of the sensor.
In that case, adjust the body side stroke in such a way that the
body side stopper comes in contact earlier than the sensor
side stopper.
The standard for adjustment is 1mm clearance between the
sensor side lever and stopper under the condition than the
body side lever touches the stopper. (See the following
illustration.)
• Be sure to set the sensor lever that sensor lever should be
contacted with idling stopper by adjusting body control lever
while body or equipment do not operate (while vehicle is
driving).
The clearance indicated for the stroke stopper of accelerator
stopper is just for reference. If the sensor side stopper comes
into contact earlier, a forcible stress will be imposed on the
sensor shaft and it may result in the damage of the part in
cause.
Moreover if sensor lever do not came into contact with idling
stopper may result in a bad condition of the engine while
vehicle to be driving.
5 - 3 - 4