Precautions For Fitting And Storing The Caution Plate - Hino Motors 300 Series Mounting Manual

PRECAUTIONS FOR FITTING AND STORING THE CAUTION PLATE

1) How to Stick It
2) How to Store It
3) Other Precautions for the Caution Plate
KK-XZU215C
a. Stick the caution plate to a dry place which is free from dust
and dirt after the paint has completely dried up.
b. Clean your hand and don't use cotton work gloves, etc..
c. Completely remove water, oil, dust, etc. from the surface to
stick (surface of cab) with ethyl alcohol if they are found
remaining there.
d. When the temperature is less than 10°C, warm up the
surface to stick as well as the caution plate with warm wind
of more than 20°C before sticking the caution plate.
e. After sticking the caution plate, press it with a roller, etc.,
with a force of approximately 49 N/cm
f. Remove liner paper (backing paper) just before using it.
g. When air remains inside, make a tiny hole with a needle or
a cutter knife and press it out with your fingers from the
bubble area.
When storing the caution plate, select a dry place with an
ambient temperature (of 20 to 25°C) and without dust, dirt and
stain.
Also, store the caution plate at a flat place such as a shelf,
etc., and do not place anything on it.
a. As the caution plate is made from vinyl chloride, it is thin,
soft and easily extendible.
Therefore, take utmost care for handling it.
b. When removing the caution plate, etc., be careful not to
damage the painted surface with a sharp knife, etc.
On the other hand, removal of the caution plate can be done
more easily by pulling the caution plate in perpendicular
direction to the sticking surface while heating it with a hair
dryer.
c. Do not throw the caution plates away but keep them
together to compare with new caution plates and to prevent
mixing up with the new ones.
7 - 6
2 {5 kgf/cm 2 }.