Precaution Of Top Coat Painting For Cab - Hino Motors 300 Series Mounting Manual

7 - 2 - 1

PRECAUTION OF TOP COAT PAINTING FOR CAB

1) Cautions for Cab Painting
When painting the cab, take a caution to the following points, other
than above.
(1) The place and parts to be omitted from painting for cab and
2) Caution when Drying
mounting body as well as adhesion of all kinds of oil:
• Various kinds of the ornaments, marks.
• Various kinds of caution plates, labels.
• Relating equipments and parts to the brake as well as a
brake hose.
• Various types of rubber hoses.
• Electrical wiring, connectors, electrical lamps, electrical
switch, relating equipments and parts.
• Back-up buzzer, noise emitting hole of electric horn.
• Rubber and plastic parts of cab, engine, chassis
suspension and steering system.
• Rubber hose for cab-tilt, piston rod of the cylinder for cab-
tilt. (The vehicle with a hydraulic cab-tilt, driven by an
electrical motor)
• Batteries
• Wiper blade, washer nozzle.
• Installing surface of disc to the disc wheel. (Including the
hub to be contacted and contacting surface of drum, disc
wheel as well as contacting surface of hub nuts.)
Then, when stained paint to the inner part of the cab,
cleaning it with a neutral detergent, do not use gasoline or
thinner.
• When you use forced drying, a temperature on the surface of
any parts to be painted must be 80°C as an upper limit.
Removing off any plastic parts, rubber parts from the vehicle,
paint them when you use a forced drying at over 80°C. (Refer
to the figure as shown below.) Take care to those as plastic
parts like fender, air cleaner, etc. are much used.
• When a vehicle with air-conditioning whose all piping and
hosing are heated at abnormal temperature
(more than 100°C), a pressure safety valve may function and
come out refrigerant gas.
KK-XZU215C