Table of Contents
Advertisement
AMETEK CTS
3.
Before Activating the Equipment
3.1.
Unpacking and inspection
The instrument was tested before shipment and was packed carefully on a transport palette. Each box is
marked with a detailed list of the contents.
Before activating the equipment, check for damage which may have occurred during shipment. Check each
container as well as the generator itself. In case of physical damage, contact the manufacturer before operating
the unit.
ESD simulators are packaged in a plastic carrying case or cardboard box. These contain fitted foam, suitable for
safely holding the simulators during transport. These containers must be retained and used when shipping the
unit for calibration, repair or maintenance.
3.2.
Power requirements
Prior to turning the equipment on, check that the selected voltage corresponds to the supply voltage listed on
the bottom of the power supply or charger.
3.3.
Charging the battery
Power to the instrument is provided through a universal mains unit suitable to your region. Ensure that your
mains power conforms to the label on the power supply. To charge, connect the provided charger to the bat-
tery.
Charging of the battery takes between two to four hours.
Quick Start and Safety Guide
V 1.0
ESD Simulators
9 / 17
Hide quick links:
Advertisement
Table of Contents
