Safety; Safety Aspects; Safety And Warning Label On The Device - Ametek esd NX30 Quick Start Manual And Safety Instructions

AMETEK CTS
1.

Safety

1.1. Safety Aspects

Observe all precautions to assure your personal safety. The generators comply with Installation Category II
(excess voltage section).
Pay special attention to safety and operation details!

1.2. Safety and warning label on the device

Take note of the following explanations of the symbols used ensure safe during operation of the equipment.
*CAUTION"
"WARNING"
Power Supply & Charger
The must be connected with mains power not to exceed 250 volts between phase and neutral or between phase
and ground. A proper ground connection through the ground connector of the power cord is essential for safe
operation.
Grounding the Generators
The generators must be grounded through the power cord. To avoid electric shock, plug the power cord into a
properly installed receptacle which was tested by a qualified electrician. Have the test performed before con-
necting equipment.
Without the protective ground connection, all parts of the generators are potential electric shock hazards. This
may include components which appear to be insulated. The equipment MUST NOT BE USED if this protection
is altered.
Use the Proper Power Cord
Use only power cords and connector specified for your product. Use only power cords in good condition.
Do Not Remove Covers or Panels
To avoid personal injury, do not operate the generators without panels and covers.
Do Not Operate in an Explosive Environment
Electric Overload
Never apply power to a connector which is not specified for that particular voltage/current.
Quick Start and Safety Guide
This symbol warns of a potential risk of shock hazard. The symbol on an instrument shows that
that it can source 1000 volt or more, including the combined effect of normal and common mode
voltages. Use standard safety precautions to avoid personal contact with these voltages.
This symbol indicates where a caution is required. Refer to the operating instructions located in
the manual in order to protect against personal injury or damage the equipment.
Indicates protective Ground Terminal
GROUND
The "CAUTION" symbol indicates a potential hazard. It calls attention to a procedure, practice or
condition which, if not followed, could possibly cause damage to equipment. Such damage may
invalidate the warranty. If a "CAUTION" is indicated, do not proceed until its conditions are fully
understood and met.
The "WARNING" symbol indicates a potential hazard. It calls attention to a procedure, practice
or condition which, if not followed, could possibly cause bodily injured or death. If a "WARNING"
is indicated, do not proceed until its conditions are fully understood and met.
V 1.0
ESD Simulators
4 / 17