Display Version - Astoria Core600 AL Use And Maintenance Manual, Instructions For The User

7.1.3 Programming the cup warmer
To adjust the cup warmer temperature, proceed as
follows using the right-hand side push button panel:
• When the machine is turned on, wait for all of the
button LEDs to come on and then immediately press
the button: the flashing LED will indicate the
current configuration of the cup warmer, as shown
in the diagrams below;
• Hold down the button until the LED on the panel
goes from a flashing to a steady light;
• Press the key that corresponds to the desired con-
figuration;
• Confirm the operation by switching the machine off
and back on.
60°C
90°C
Cup warmer
7.1.4 Programming the standby
To put the machine in standby mode, i.e. switch it off
whilst keeping the push button panel active, proceed
as follows:
• Press the button on the right-hand side push
button panel and the
afterwards;
• The machine is in standby mode when the
button's LED flashes;
• To exit the standby mode, press the
USER manual
70°C 80°C
110°C
100°C
button immediately
button.

DISPLAY version

7.2
7.2.1 Programming the coffee dispenses
The machine is programmed by default. Should the
coffee doses need to be modified, proceed as follows:
• Always programme the right hand push-button panel
first. In this way all push-button panels get automati-
cally programmed. If necessary,
subsequently programme the
others;
• Place the cup under the dispens-
ing spout;
• Press the button for at least
5 seconds, until all the dose but-
ton LEDs are lit;
• Press the desired dose button,
for example ;
• To confirm the dose, press the
button again or the
button;
• Repeat this operation for the
other dose buttons;
• When the programming is com-
plete, press the button until
all of the LEDs on the push but-
ton panel go off.
Programming of every dose must be carried out with ground coffee
and not with previously used coffee dregs.
65 288
of