Table of Contents
Advertisement
Available languages
Available languages
4.
Pull out the support leg, and adjust it to the maximum angle.
EN
5.
Adjust the length of the support leg so that it is in full contact with the ground of the vehicle. The display window turns into a green colour.
6.
Select a rear-facing recline position 5 (blue).
NOTE: For children of this size, the child seat must only be installed in the rearward facing position and at a maximum angle of inclination
(lying level). To make sure that the car seat has been installed correctly, please shake it before use.
NOTE: Test by pulling on the enhanced child restraint system to ensure it is locked.
INSTALLATION WITH ISOFIX AND SUPPORT LEG (76-105 CM)
IMPORTANT - DO NOT USE FORWARD FACING BEFORE THE CHILD'S AGE EXCEEDS 15 MONTHS.
1.
Place enhanced child restraint system forward-facing (in the direction of travel) in proper seating location, flat on the vehicle seat
bottom and touching vehicle seat-back.
2.
Press the ISOFIX button to pull out the two ISOFIX locking arms from the base bottom.
the indicator turns into a red colour, which means ISOFIX attachments are unlocked.
NOTE: The ISOFIX attachment points are located between the surface and the backrest of the vehicle seat.
3.
Align ISOFIX attachments to the metal anchorages at the bottom of the car seat's backrest and push it until it clicks.
an audible CLICK! Ensure the both sides of the ISOFIX locking arms turn into green safety colour.
CAUTION: After the ISOFIX installation check if the enhanced child restraint system is securely fitted. If the enhanced child restraint
system is not stable and is shaking, reinstall.
4.
Pull out the support leg, and adjust it to the maximum angle.
5.
Adjust the length of the support leg so that it is in full contact with the ground of the vehicle. The display window turns into a green colour.
6.
Select a forward-facing position from 1 to 4 (red).
NOTE: Test by pulling on the enhanced child restraint system to ensure it is locked.
SECURING THE CHILD
WARNING: If your child is not properly secured in the enhanced child restraint system, they may be ejected in a crash, resulting in serious
injury or death.
1.
Spread the 5-point harness straps apart.
2.
Place your child in the enhanced child restraint system in a seated position.
3.
The child should be seated against both the back and bottom of the seat with no gap behind the child. Do not allow the child to
slouch. Gently guide the child's arms through the 5-point harness loops.
4.
Insert buckle tongues into the buckle. Check the shoulder straps height. Straps must be well fitted and not twisted!
CARE, CLEANING AND MAINTENANCE, STORAGE
• WARNING: It's dangerous to make any alterations or additions to the device without the approval of the Type Approval Authority, also
dangerous not to follow closely the installation instructions provided by the child restraint manufacturer.
• WARNING: Do not attempt to disassemble the enhanced child restraint system further than these instructions allow.
• WARNING: All car seats expire. Plastic and metal parts wear out over time. Contact the manufacturer if you are unsure when your seat expires.
• When the chair is not provided with a textile cover, the chair should be kept away from sunlight, otherwise it may be too hot for the
child's skin. Although, the enhanced child restraint system must not be used without the cover. The seat cover should not be replaced
with any other than the one recommended by the manufacturer. The cover constitutes an integral part of the restraint performance.
• Check regularly if everything functions properly.
• If any parts are torn, broken, or missing, stop using this product.
• DO NOT attempt to remove the foam under the seat pad.
• Keep the enhanced child restraint system clean.
• Do not use abrasive cleaning agents or hard objects during cleaning as these can damage the product.
• To clean the buckle: rinse using warm water. DO NOT use any soaps, solvents, or lubricants. Using anything other than water can cause
the buckle to malfunction. Air dry.
• Removable fabric covers and trims may be cleaned using warm water with a household soap or a mild detergent.
30
Wash in maximum 30 °C.
• Remove the enhanced child restraint system from the vehicle seat if not in use for a long period of time. Store the product in a cool, dry
place, protected from moisture and direct sunlight and somewhere your child cannot access it.
• Avoid placing heavy objects on top of the seat.
• It is normal for the fabric to colour from sunlight and to show wear and tear after a long period of use, even when used normally.
TECHNICAL DATA
Overall dimensions
(millimetre)
Weight
34
CLICK
green
Do not tumble dry.
Length
Width
Height
12.05 kg
Do not bleach.
580
440
620-820
You will hear an audible CLICK!
Do not iron.
Do not dry clean.
440mm
580mm
Ensure that
You will hear
Advertisement
Table of Contents
