Point Harness; Rear-Facing Installation - NORAUTO 2274268 Safety Information Manual

Enhanced child restraint system
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 31

5-POINT HARNESS

REMOVAL AND ACCESSORY STORAGE
1.
To remove shoulder pads and straps, first loosen the 5-point harness of the enhanced child restraint system as much as possible.
Then, remove the straps from the metal links. Store the straps on the back of the backrest.
2.
Take the gears fixed axle from the plastic stator and store it on
the back of the backrest.
3.
Finally, insert redundant belt into cloth cover.
4.
To store a buckle,
press the straps release button to release
the buckle tongues.
5.
Pull down the buckle cover.
6.
Lift the cover in the PE board and hide the buckle.
SLEEPING PAD AND HEADREST CUSHION REMOVAL
• CAUTION: When your child's height exceeds 61 cm, remove the sleeping pad.
• CAUTION: The headrest cushion is suitable for infants from 0 to 8 months only. Remove the headrest cushion
when your child exceeds 8 months.
SEAT COVER REMOVAL
1.
Set headrest in the highest position.
2.
Remove the 5-point harness.
3.
Remove the cover from the backrest and base.
4.
First, remove the cover from the base of the headrest, then remove the cover from the headrest.
To reattach the cover, reverse the above steps.
CAUTION: Do not use enhanced child restraint system without the cover.
CAUTION: Check that the harness straps are not twisted and that they are correctly inserted into the slots of the cover's straps.
INSTALLATION
WARNING: If the child is not secured properly, child could be ejected in a sudden stop or crash, resulting in serious injury or death.

REAR-FACING INSTALLATION

It is recommended that children ride in a rear-facing enhanced child restraint system until they are at least 2 years old. An infant's head,
neck, and spine are not supported as well in a forward-facing position.
INSTALLATION WITH ISOFIX AND SUPPORT LEG (40-105 CM)
1.
Place enhanced child restraint system rear-facing in a compatible vehicle seat.
2.
Press the ISOFIX button to pull out the two ISOFIX locking arms from the base bottom.
the indicator turns into a red colour, which means ISOFIX attachments are unlocked.
NOTE: The ISOFIX attachment points are located between the surface and the backrest of the vehicle seat.
3.
Align ISOFIX attachments to the metal anchorages at the bottom of the car seat's backrest and push it until it clicks.
an audible CLICK! Ensure the both sides of the ISOFIX locking arms turn into green safety colour.
CAUTION: After the ISOFIX installation check if the enhanced child restraint system is securely fitted. If the enhanced child restraint system
is not stable and is shaking, reinstall.
green
CLICK
2
You will hear an audible CLICK!
EN
3
1
Ensure that
You will hear
33

Advertisement

Table of Contents
loading

Table of Contents