Table of Contents
Advertisement
M68EML08EY Quick Start Guide
3 - Connect the emulation module to your target system
4 - Install the development software
5 - Copy personality files to your computer
M68EML08EY Emulation Module - Version 1.0
8
•
Fit together M68EML08EY connectors P1 and P2 (on the bottom of the
board) to connectors P11 and P12, respectively, of the MMDS or
MMEVS (P6 and P7 on some MMEVS boards) control board and snap
the corners of the M68EML08EY onto the plastic standoffs.
Use the supplied target flex cable, appropriate target head adapter, and surface
mount adapter. Plug the appropriate end of the flex cable plugs into
M68EML08EY connectors J2 and J3.
•
If the M68EML08EY is in an MMDS station module, run the flex cable
through the slit in the station-module enclosure, then replace the access
panel.
•
Plug the other end of the flex cable into the target head. Solder the
appropriate surface mount adapter to your target if necessary. Then plug
the target head into the surface mount adapter on your target system.
The factory ships M68EML08EY MCU personality files on the documentation
CD-ROM.
•
If you're using the CodeWarrior IDE, find the installation directory and
copy the personality files named 00C31Vxx.mem and 00C32Vxx.mem
from the documentation CD-ROM to the ...\prog\reg subdirectory
of the CodeWarrior IDE main directory.
•
If you're using the P&E debugger, copy these files to the installation
directory that contains MMDS08.EXE or MMEVS08.EXE and rename
them from 00C31Vxx.mem and 00C32Vxx.mem to 00431Vxx.mem and
00432Vxx.mem respectively.
M68EML08EY Quick Start Guide
User's Manual
MOTOROLA
Advertisement
Table of Contents
