Commissioning
completed
Fault 420
Commissioning is completed when the following message is
displayed.
Confirm the message with OK.
The washer-disinfector is now ready for use.
The settings made during the commissioning process are only
adopted after a complete programme has been run.
Select any programme, e.g.:
Press the Start/Stop button to start the programme.
After commissioning, every programme starts with reactivation of
the water softener.
If the programme is cancelled using
plumbing connections are deactivated.
Confirm the error message with OK.
Switch the machine off using the button.
Wait approximately 10 seconds before switching the machine on
again with the button.
The commissioning procedure starts again.
Perform commissioning and activate at least one plumbing
connection; e.g. for cold water.
Set up successful
Short
Temperature
60 °C
Duration
20
Drain
.
Fault 420
Commissioning
Min
, this means that all the
27