Adding and dispensing chemical agents
Refill indicator
Dispensing
50
Wipe up any spilled process chemical thoroughly. Then start the
Rinsing
programme to prevent over-foaming occurring during the
next programme.
When the fill level is low in the (DOS 2) supply container for
neutralising or rinsing agent you are reminded to refill it.
This message also appears when dispensing neutralising agent.
When refilling the reservoir make sure you are using the correct
chemical agent.
Confirm the message shown with OK and
refill the chemical agent as described above.
For adjusting the dispensing concentration, see "Further settings/
Additional functions/Dispensing systems".
If spots appear on items after processing:
reduce the amount if using neutralising agent.
increase the amount if using rinsing agent.
If clouding or smearing appears on items after processing:
increase the amount if using neutralising agent.
reduce the amount if using rinsing agent.
Refill rinsing agent