Selecting The Store Location - JDS Uniphase cOPM-A1 Operating Manual

6 M
EMORY

Selecting the store location

When you press [Store] in measurement mode, the
results are stored at the active memory location. Each
time you press the key, the Meas # is incremented but
the Group # remains the same. You cannot select the
memory location, Meas # or Group # in measurement
mode.
If you do not want to overwrite existing data or if you want
to set a specific Group and Meas number, you must
open the MANAGE MEMORY menu and select the
location.
The procedure is the same as for displaying a memory
location (see
the last memory location displayed is always set as the
current memory location when storing data.
To save results at a selected location:
1. Set the wavelength and measurement mode as
required.
2. Select Manage Memory in the MAIN menu.
3. Press [▲▼] to edit the Meas # only.
Go to step 9 if you only want to edit the Meas #.
4. Press [MENU ENTER].
The MANAGE MEMORY menu opens.
5. Press [MENU ENTER] again (Select Group is
highlighted).
The current Group # and Meas 001 are displayed.
6. Press [▲▼] to edit the Group #.
7. Press [MENU ENTER].
Meas # is highlighted.
8. Press [▲▼] to edit the Meas #.
9. Press [PREV] to exit from the menu.
⇒ Press [Store] to store the results.
32
M
ANAGEMENT
„Displaying stored results", page
cOPM-A1
30), as
JDSU