Step 4: Specifying The Ap And Station Location; Assessing An Installation Site - JDS Uniphase WiFi Advisor User Manual

Chapter 3 Testing
Assessing WiFi performance throughout a site
7 If you wish to specify an additional secondary profile, touch Add Profile
located under Secondary Profiles.
8 Touch the back arrow to return to the Select Configuration page.
The new configuration is saved and can be selected for future tests.
To delete a configuration
To delete a configuration, touch and hold the configuration until it is highlighted, and
then swipe to the left. A Delete button appears. Tap the Delete button.

Step 4: Specifying the AP and Station Location

These settings specify the room where each WiFi Advisor is located.
To specify the AP and Station location
1 From the Site Assessment page, select AP Location.
2 Select the room where the Access Point is located. If the location you desire
is not listed, select Add Location.
3 From the Site Assessment page, select Station Location.
4 Select the room where the Station is located. If the location you desire is not
listed, select Add Location.

Assessing an installation site

Two-ended site assessment uses two WiFi Advisors to test connectivity and assess
an installation site. The following procedure describes how to assess an installation
site.
To assess an installation site
1 Bring an iPad and two WiFi Advisors to the site.
2 Open the WiFi Advisor app on the iPad.
Page 30
WiFi Advisor Wireless LAN Analyzer User's Guide
22073751, Rev. 002 December 2014