Unpack the Hoist
When you open the box, your hoist is lying on its side. There is also a smaller box inside the
large box that includes the TwinLine wire rope, TwinLine clamps, SafeStop brakes, and stop
sleeves for terminating the wire rope to the drum.One end of the wire rope is pre-terminated to
the TwinLine clamp and the other end is loose, with the excess spooled inside cardboard. You
can use the box to rotate the hoist so it is standing upright on the foam blocks that were used as
packing material.
CAUTION:
TwinLine wire ropes free of debris. The use of damaged or dirty wire ropes can
interfere with proper hoist function.
Once the hoist is unpacked, rest it on top of stands or saw horses so that it is up off the ground.
This provides the space you'll need when terminating the TwinLine lift lines to the drum.
Attach TwinLine Clamps
Once you have positioned your hoist, you must run the TwinLine and TwinLine clamps up to the
strut channel. To secure the clamps to your strut channel, perform the following steps. If you are
installing helix cable management, you should hang the cable assembly before attaching the
TwinLine clamp for the second set of lift lines that run through the cable assembly. For
instructions on hanging the cable assembly, refer to
on page 10
.
Note:
distance of wire rope plus 41 cm (16 in) minimum dead hang to be run up when
attaching the TwinLine clamps.
CAUTION:
following:
- The TwinLines are not twisted at any point in the run
- The cable equalizer plate is perpendicular to the clamp body
1. Run the TwinLine and TwinLine clamp up to the strut channel attached to the building
structure.
2. Rotate the channel nut so the long sides are parallel with the run of strut channel. This
ensures that the nut can be inserted into the channel.
Initial Hoist Installation
While unpacking hoist assembly, it is important to keep the
The hoist must rest in a position that will allow for the entire intended travel
Before attaching the clamp to the strut channel, ensure the
Hang Helix from Upper Attachment Points
7
Need help?
Do you have a question about the Prodigy FlyPipe Studio and is the answer not in the manual?