Class 104 Objects (Read Only); Supported Services For Vendor-Specific Objects - Danfoss VLT Soft Starter MCD 600 Installation Manual

EtherNet/IP Card
Installation Guide
Object name
1 = Multiply power by 100 to get W
2 = Power (kW)
3 = Multiply power by 10 to get kW
% Power factor
Average rms voltage across all 3 phases
Phase 1 current
Phase 2 current
Phase 3 current
Phase 1 voltage
Phase 2 voltage
Phase 3 voltage
Parameter list minor version
Parameter list major version
Digital input state
For all inputs, 0 = open, 1 = closed (short-circuited)
Start/stop input = 01h, reset = 04h, programmable input A = 08h, programmable input B = 10h
The reset input is normally closed by default. If parameter 7-9 Reset/Enable Logic is set to normally open, the reported state is
inverted (0 = closed, 1 = open).

7.2.2.3 Class 104 Objects (Read Only)

Class 104d (0x68) allows extended information to be read from the soft starter.
Object name
Major software version - User interface
Minor software version - User interface
Major software version - Motor control
Minor software version - Motor control
Major software version - Remote LCP (if installed)
Minor software version - Remote LCP (if installed)
Major software version - Expansion card (if installed)
Minor software version -. Expansion card (if installed)

7.2.3 Supported Services for Vendor-specific Objects

This section describes the operational instructions to carry out acyclic services on class objects 100, 101, 103, and 104.
22 | Danfoss A/S © 2020.12
N O T I C E
Class Instance
103 122
103 123
103 124
103 125
103 126
103 127
103 128
103 129
103 130
103 131
103 132
Class Instance
104 101
104 102
104 103
104 104
104 105
104 106
104 107
104 108
AN353423548483en-000101 / 130R0945
Messaging
Attribute
100
100
100
100
100
100
100
100
100
100
100
Attribute
100
100
100
100
100
100
100
100