EtherNet/IP Card
Installation Guide
4.5.3 Configuring the IP Address
For version 1.x of the EtherNet/IP Card, changes made via the web server are not stored in the soft starter and will be lost when
control power is cycled.
1
2
Procedure
1.
Connect to the web server and click IP Setting.
2.
Edit settings as required. To enable DHCP addressing, tick the DHCP checkbox.
3.
Click Submit to send the new settings to the device.
4.5.4 Configure IoT Settings
The EtherNet/IP Card supports soft starter status monitoring via IoT. The card cannot control or program the soft starter.
Version 1.x of the EtherNet/IP Card does not support IoT operation.
12 | Danfoss A/S © 2020.12
N O T I C E
3
N O T I C E
Device Configuration
AN353423548483en-000101 / 130R0945