Armrest, Height Adjustable, Removable; Leg Rests; Angle Adjustable Legrest - Invacare Rea Spirea 4 NG User Manual

3.11.3 Armrest, height adjustable, removable

Removing
1. Previously press on the locking mechanism A located
at the bottom of the armrest vertical bracket (if so
equipped).
2. Pull the armrest by the arm cushion out of the holder.
Fitting
1. Push the armrest into the holder.
Adjusting the armpad height
1. Loosen the screw B with 5 mm Allen key at top of the
armrest tube.
2. Move the armrest upwards or downwards until you
reach the desired height, while keeping screw B in
place.
3. Tighten the screw B (5–6 Nm).
4. Perform the setting on both sides.
Adjusting the armpad depth
1. Loosen the 2 screws C below the armrest bracket.
2. Move the armrest frontwards or rearwards until you
reach the desired depth, while keeping screw C in place.
3. Tighten the 2 screws C (1,5–2 Nm).
4. Perform the setting on both sides.
Adjusting the side protection height
1. Loosen the 2 screws of the side protection clamps D.
2. Move the side protection upwards or downwards until
you reach the desired height.
3. Tighten the 2 screws of the side protect clamps D
(0,7–1,2 Nm).
4. Perform the setting on both sides.

3.12 Leg rests

WARNING!
Risk of injury
– Never lift the wheelchair by the footrest
supports or leg rests.
CAUTION!
Risk of pinching or crushing fingers
There are swing mechanisms where you could
trap your fingers.
– Be careful when using, swinging, disassembling
or adjusting these mechanisms.
1536533-F
IMPORTANT!
Risk of damage to the leg rest mechanism
– Do not place anything heavy, or let children sit
on the leg rest.

3.12.1 Angle adjustable legrest

Angle adjustable legrests support the legs and reduces
pressure. The legrests must always be fitted with calf pads,
foot plates and heel straps. It is important to adjust the
height and angle of the legrests to obtain a good seating
position.
Adjusting the legrest height
1. Loosen screw A with an allen key.
Tools: 5 mm allen key
2. Adjust the legrest to a suitable height and the screw is
caught by one of the recesses on the legrest tube.
3. Re-tighten the screw with 8 Nm.
Angle adjustment
WARNING!
Risk of damage
Damage on the mechanism
– Do not place anything heavy, or let children sit
on the legrest. It may cause damage to the
mechanism.
– Do not put any pressure on the legrest while
the angle is being adjusted. The lever must be
fully opened.
A
Product Overview
A
13