Table of Contents
Advertisement
Rea® Spirea® 4 NG
3.10 Mudguard
In order to prevent dirt from the wheels spraying upwards,
a removable mudguard can be fitted. The position of the
mudguard can be adjusted.
Removing
1. Pull the mudguard upwards out of the holder.
2. To adjust how easy or difficult it is to pull the mudguard
out of the holder, change the degree to which the
screws D are tightened.
Fitting
1. Push the mudguard into the holder.
Adjusting the height
1. Loosen the screw B with 10 mm spanner in the groove
C of the armrest tube.
2. Move the armrest upwards or downwards until you
reach the desired height, while keeping screw B in
place (at the top edge of the holder).
3. Tighten the screw B (5–6 Nm).
4. Perform the setting on both sides.
3.11 Armrests
WARNING!
Risk of injury
The side rests are not locked and can be easily
pulled out upwards.
– Do not lift or transfer the wheelchair using the
side rests.
– Do not use the side rests for transportation
when carrying the wheelchair up- or downstairs.
CAUTION!
Risk of pinching
– Keep your fingers away from movable parts
during removing, fitting or adjusting the
armrest.
12
3.11.1 Detachable armrests
1. Loosen the screw A.
2. Adjust the armrest height to the required position.
3. Re-tighten the screw.
4. Repeat the procedure on the opposite side.
Tools: 5 mm Allen key
3.11.2 Armrest, stepless height adjustable,
removable
Removing
1. Apply the parking brake on both sides.
2. Previously press on the locking mechanism A located
at the bottom of the armrest vertical bracket (if so
equipped).
3. Pull the armrest by the arm cushion out of the holder.
4. To adjust how easy or difficult it is to pull the armrest
out of the holder, change the degree to which the
screws D are tightened.
Fitting
1. Push the armrest into the holder.
Adjusting the height
1. Loosen the screw B with 5 mm Allen key in the groove
C of the armrest tube.
2. Move the armrest upwards or downwards until you
reach the desired height, while keeping screw B in
place (at the top edge of the holder).
3. Tighten the screw B (5–6 Nm).
4. Perform the setting on both sides.
A
1536533-F
Advertisement
Table of Contents
