To Use Busy Autoredial; To Call Back; To Activate Forwarding Service; To Switch Do Not Disturb Mode - Epygi Quadro2x Manual

Epygi Technologies
6.2.1

To Use Busy Autoredial

Service is functional for SIP and PBX calls only. For PSTN calls, feature works as a single redial (with no multiple
attempts to reach the called destination).
to redial the last number that you called.
Dial
If the called number is busy, after dialing
automatic redialing of the last called number for the time period specified on the Autoredial
Settings page (User login Call Handling Autoredial).
The autoredial terminates as soon as
1. The called number is idle and you hear ring back tones,
2. The specified Autoredial Period has expired.
A beep sound will be heard if no autoredialing is possible.
6.2.2

To Call Back

Dial . The system will call back the last caller.
"The dialed number doesn't exist" voice message will be played if no call back is possible.
6.2.3

To Activate Forwarding Service

Dial and hang up. The Unconditional Call Forwarding service with the settings specified for Any
Address/Other Addresses on the Caller ID Based Services page will get activated (User login
Supplementary Services).
Use the same key combination to deactivate the service.
The feature code will have no effect if no unconditional forwarding is configured for Any
Address/Other Addresses. Instead, the system will ask to configure the forwarding settings first.
6.2.4

To Switch Do Not Disturb Mode

Dial and hang up. Your phone bell will be off during the period indicated on the Do Not
Disturb Settings page (User login Call Handling) and all incoming calls will be directly forwarded
to your voice mail (if the voice mail service is activated).
Use the same key combination to deactivate the DND service.
6.2.5

To Block Last Caller

Dial . The last caller will be blocked and a corresponding entry will be added to the Caller ID
Based Services (User login Supplementary Services) page.
Attention: This service can be activated within 10 seconds after call termination. To unblock the
blocked party, go to the Caller ID Based Services page and disable the Incoming Call Blocking
service for the blocked address. If no other services are enabled for the address, you may delete the
entry from the table.
Blocking the caller with anonymous caller ID (like anonymous@anonymous or similar) will lead to
blocking all callers with unknown caller address.
, stay with the handset lifted to activate the
PAGE 8
Using Quadro Features on IP Phones
29 May 2006