Servo Installation; Bottom View - VQ Models Cap 10 Instruction Manual

60 class 2-cycle engine, 90 class 4-cycle engine
Table of Contents

Advertisement

1- Servo installation / Servoeinbau
L/R
Plastic control horn
............................4
2x20mm screw
.......................8
Linkage Stopper set
......................2
2- Servo installation / Servoeinbau
Flap servo hatch
(plywood)
X
3- Servo installation / Servoeinbau
2x10mm screw
Flap servo
Flap servo hatch
X
Aileron servo
extension cord
1-When you are satisfied with the alignment of the control horn mark the mounting hole
positions with a felt tipped pen or a pencil.
2-Remove the control horn and drill two 2mm (5/64") holes through the ailerons and flaps.
3-Attach the control horn using two 2x20mm screw and a back plate.
2x10mm
screw
X
Servo mount
1- Place the flap servo onto the servo mounts and secure it in place using
the four screws included with the servo.
2- Install the flap push rod connector onto the hole in the flap servo arm
and insert the push rod through the push rod connector.
3- Place the flap servo hatch in its mount and secure it in place using four
2x10mm screws.

BOTTOM VIEW

Unteransicht
2x20mm screw
2mm
Flap push rod exit
Aileron servo
CAUTION: one of the flap servos is revert servo
TOP
Push rod exit
Flap servo hatch
Plastic back plate
BOTTOM
Plastic control horn
2x20mm screw
2x20mm screw
1.2mm
BOTTOM VIEW
Unteransicht
Aileron
push rod
Flap push rod
2mm
L/R
L/R

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Cap 10 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents