System Information Dialog - AMX AXT-CA10 Instruction Manual

Using the DXP-PRO Wizard

System Information Dialog

The first dialog in the Project Wizard is the System Information dialog (FIG. 2). This dialog
contains the information used by Design XPress Professional (DXP-PRO) version 1.1 to create and
program the control system. Double-click on any device in the list to access the Device
Configuration dialog, containing all control information associated with the device.
FIG. 2 System Information dialog
The following list describes the items in the System Information dialog:
Note that since the Job Name, Created By and Company names are also used in the NetLinx
program, the characters that you are allowed to use are A-Z, a-z, 0-9, - and _. These fields are all
limited to 40 characters.
22
• Job Name: Enter the name of the project here. Each new project should be given a
unique Job Name and Description.
• Created By: This field is pre-populated, if this information was entered in the User
Information dialog. Otherwise, enter or edit the name of the project author
here.
• Company: This field is also pre-populated, if this information was entered in the User
Information dialog. Otherwise, enter or edit the name of the company here.
• Description: Enter a description of the project here (8190 characters maximum). Any
alphanumeric character (including punctuation) can be used. Each new
project should be given a unique Job Name and Description.
• Lighting System: Click the down-arrow to open a drop-down list of lighting systems
supported by DXP-PRO. Select the lighting system you are using, or select
No Lighting Control (at the top of the list) if your project does not include
any lighting control.
Additional fields may be displayed depending upon the device configura-
tion requirements of the selected lighting system. For example, the
LiteTouch 5000LC displays a combo box to select the baud rate for com-
munications with the LiteTouch controller. However, the AMX Radia sys-
tem does not have a Baud Rate combo box because it communicates via
AXlink.
In addition to selecting the lighting system, DXP-PRO will automatically
select the default baud rate if applicable. You can manually set the baud
rate for non-standard systems.
DXP-PRO v1.1 - Programmer's Guide