Lighting Presets Dialog - AMX AXT-CA10 Instruction Manual

Using the DXP-PRO Wizard

Lighting Presets Dialog

The Lighting Presets dialog (FIG. 10) sets up the available presets for the Lighting system selected
on the System Information page. There is a maximum of nine presets available. DXP-PRO does not
allow for individual zone control or the setting of presets, only the recall of existing presets.
FIG. 10 Lighting Presets dialog
The defined lighting presets appear in the Lighting Presets table. You can sort the presets by
clicking on the header cell for any of the columns. Clicking the header cell toggles sorting to either
ascending or descending order.
44
Click on a cell within the Lighting Presets table to select the preset for editing.
Select a Preset and click the up/down arrows to the right of the Lighting Presets table to
rearrange the order of presets.
The identifier entered into the Preset Name text box is the name that will be displayed on
the touch panel. No duplicates allowed (8 characters maximum).
The Address and Button Number fields correspond to either the lighting controller
address and the preset number (as with AMX Radia), or the address of the keypad and the
keypad button that will be emulated (as with the LiteTouch controller).
For the AMX ALD-D48, the Address field value is fixed at a value of one (1) and
greyed-out. This value corresponds to the Device ID of the keypad.
For the AMX Radia the address is the AXlink address of the Radia MC.
The only valid keypad address characters are 0-9, A-F, and : (colon). For reference,
here are the formats for the various supported lighting systems:
DXP-PRO v1.1 - Programmer's Guide