Table of Contents
Advertisement
• OUT PORT FUNC
Sets what type of signal the MIDI OUT port sends.
• MIDI sets the port to send MIDI data.
• DIN24 sets the port to send DIN 24 sync pulses. No MIDI data can be sent on the port when this
option is selected.
• DIN48 sets the port to send DIN 48 sync pulses. No MIDI data can be sent on the port when this
option is selected.
• THRU PORT FUNC
Sets what type of signal the MIDI THRU port sends. The settings are the same as for OUT PORT
FUNC.
• INPUT FROM
Sets the source from which the Analog Heat MKII receives MIDI data.
• MIDI Only receives MIDI data from the MIDI IN port.
• USB Only receives MIDI data from the USB port.
• MIDI+USB Receives MIDI data from both the MIDI IN and USB port.
• NONE Disregards any incoming MIDI data.
• OUTPUT TO
Selects the port to which Analog Heat MKII sends MIDI data (CC or NRPN).
• MIDI Only sends MIDI data to the MIDI OUT port.
• USB Only sends MIDI data to the USB port.
• MIDI+USB Sends MIDI data to both the MIDI OUT and USB port.
• NONE Do not send MIDI data to any port.
• PARAM OUTPUT
Sets what type of MIDI messages the DATA ENTRY knobs sends. For information about which CC/
NRPN parameters that are sent, please see "APPENDIX A: MIDI" on page 34.
• CC Sets the knobs to send CC MIDI messages.
• NRPN Sets the knobs to send NRPN MIDI messages.
• ENCODER DEST
Sets whether or not the DATA ENTRY and LEVEL knobs send MIDI data.
• INT MIDI only sends data internally.
• INT + EXT MIDI sends data both internally and externally.
• PARAM INPUT
Makes it possible to control Analog Heat MKII parameters from an external MIDI device sending
CC/NRPN data. (ON, OFF)
6.6.3 CHANNELS
• MIDI CHANNEL
Sets the MIDI channel that Analog Heat MKII uses to send and receive MIDI data. When set to OFF,
all MIDI functionality is disabled. (1–16)
6.7 SYSEX DUMP
In the SYSEX DUMP menu, settings and Presets can be sent and received. Select a menu option using the
PRESET/DATA knob. Press [YES] to open the highlighted menu selection.
When receiving or sending SysEx data, the MIDI ports or the USB port of the Analog Heat MKII should be
connected to the external sending/receiving device.
If the Analog Heat MKII is sending or receiving SysEx data through the MIDI ports, use the Elektron TM-1
USB MIDI interface for up to 10x transfer speeds.
If the external device is a computer, we recommend using our free SysEx utility C6, which can be down-
loaded from the Elektron website.
6. THE SETTINGS MENU
21
Advertisement
Table of Contents
