Table of Contents
Advertisement
6. THE SETTINGS MENU
Using a USB audio host together with Analog Heat MKII opens up several interesting
possibilities of how to use the Analog Heat MKII. Here are some examples and how the
ANALOG IN/OUT and USB CC MODE parameters should be set to achieve them:
• Analog Heat MKII as an insert effect for the USB audio host:
ANALOG IN/OUT: IN+OUT, USB CC MODE: INSERT
• USB audio host as a pre-Heat insert effect:
ANALOG IN/OUT: OUT, USB CC MODE: PRE
• USB audio host as a post-Heat insert effect:
ANALOG IN/OUT: IN, USB CC MODE: POST
• Analog Heat MKII as a transparent sound card for the USB audio host:
ANALOG IN/OUT: OFF, USB CC MODE: BYPASS
6.5.4 USB TO MAIN
Sets the gain level of the audio sent from the USB audio host to the Analog Heat MKII. This setting only
affects the audio sent from the USB audio host to the analog OUTPUT L/R and HEADPHONES out-
puts. This parameter is only available if USB AUDIO+MIDI or OVERBRIDGE mode is chosen in the USB
CONFIG menu, and if it is included in the audio routing chosen in USB CC MODE. For more information,
please see "6.8.1 USB CONFIG" on page 23. (0 dB–+18 dB)
6.5.5 FX TO USB
Sets the gain level of the audio sent from Analog Heat MKII's FX to the USB audio host. This parameter
is only available if USB AUDIO+MIDI mode is chosen in the USB CONFIG menu and if it is included in the
audio routing chosen in USB CC MODE. For more information, please see "6.8.1 USB CONFIG" on page
23. (0 dB–+30 dB)
6.6 MIDI
These settings are stored in the global settings and are not part of the preset.
6.6.1 SYNC
• CLOCK RECEIVE
Sets whether or not the Analog Heat MKII responds to MIDI clock and transport sent from external
devices. (ON, OFF)
• CLOCK SEND
Sets whether or not the Analog Heat MKII sends/forwards MIDI Clock and transport. Transport is
transmitted when an external clock source (MIDI or Overbridge) is used. (ON, OFF)
• PROG CHG RECEIVE
Sets whether or not the Analog Heat MKII responds to incoming program change messages. This
is useful when wanting to select presets from an external source. For more information on how to
select the appropriate MIDI channel, please see "6.6.3 CHANNELS" on page 21. (ON, OFF)
• PROG CHG SND
Sets whether or not the Analog Heat MKII sends program change messages when it changes
patches. For more information on how to select the appropriate MIDI channel, please see "6.6.3
CHANNELS" on page 21. (ON, OFF)
6.6.2 PORT CONFIG
• TURBO SPEED
This setting allows Turbo mode negotiation between Elektron gear. Connecting the Analog Heat
MKII to other Turbo protocol compatible gear, like the Analog Rytm and the Octatrack, makes it
possible to increase the average MIDI bandwidth by up to 10x. This increases the accuracy of MIDI
clock signals as well as the timing of CC messages. (ON, OFF)
20
Advertisement
Table of Contents
