Depth1; Lfo; Speed; Mult - Elektron Analog Heat MKII User Manual

Stereo analog sound processor

Hide thumbs Also See for Analog Heat MKII:

Table of Contents

7. PARAMETER PAGES

7.5.4 DEPTH1

Sets the amount of how much the envelope follower affects the modulation destination. A negative value

gives an inverted modulation. (-128.00–+127.00)

7.6 LFO PAGE 1

Press [LFO] once to access this parameter page.

Sets the rate of the LFO in relation to the internal or external tempo. It is synced to BPM if one of the

"BPM x" settings are selected in the MULT parameter. To sync the LFO to straight beats, try settings of

16 or 32. The value of this parameter is bi-polar. (The LFO shape can be played backward by using nega-

tive values.) For more information, please see "6.3.1 INTERNAL TEMPO" on page 17. (-64–63)

Multiplies the SPEED parameter by the set factor. (x) multiplies the current BPM. 1-2K multiplies the LFO

speed regardless of the current internal or external tempo.

Sets the LFO waveform. (TRI, SINE, SQR, SAW, EXP, RAMP, RND)

Sets wherein the LFO waveform cycle it starts when triggered. (0–127) For example, if you set WAVE to

SAW and START to 64 it starts at the middle of the wave cycle:

7.7 LFO PAGE 2

Press [LFO] twice to access this parameter page.

The LFO has three modulation destinations.

1. The first is set using the parameter DEST1. The amount of LFO modulation added to the selected des-

tination is controlled by the parameter DEPTH1. The first modulation destination can also be set in the

MODULATION parameter page found at SETTINGS>MODULATION. Select LFO 1ST as a source and

then select modulation destination and modulation depth. For more information, please see "6.2 MODU-

LATION" on page 16.

Start

Table of Contents