2 G S COOKING HOB
3 G S COOKING HOB
2 G S +1 ELECTRIC PL TE
COOKING HOB
The cable must be replaced with a
cable of the same type.
The electrical cable must be connect-
ed to the terminal block following the
diagrams of Fig. 7.1.
FEEDER SPECI L C BLE SECTION
Type "HO5RR-F"
Cooking hobs 2 GAS and 3 GAS
220-240 VAC 50/60 Hz 3 x 0,75 mm
Cooking hob 2 GAS + 1 ELECTRIC
220-240 VAC 50/60 Hz 3 x 1,5 mm
220-240 V
L1
Fig. 7.1
2
~
PE
N(L
)
2
3 ELECTRIC PL TE
COOKING HOB
ELECTRIC L CONNECTION
To connect the mains flex to the hob,
proceed as follows:
Upturn the hob
Unscrew screws "A" and remove pro-
tection "B" (Fig. 7.3)
Insert connecting plates "C" into ter-
minal block "D" (Fig. 7.2) as shown in
the diagram in Fig. 7.4.
Unscrew cable clamp "E" (Fig. 7.3)
Insert correct section and type mains
flex (see special chapter); connect
mains and earth wires to their respec-
2
tive terminals in block "D", in accor-
dance with the diagram shown in Fig.
7.4.
Tighten mains flex, and fix it with
clamp "E".
Replace protection "B".
27