Torque Instructions - Graco ChemSafe 515 PT Instructions-Parts List Manual

Torque

Torque Instructions

Torque Instructions Instructions
If fluid cover or manifold bolts have been loosened,
it is important to torque them using the following
procedure to improve sealing.
Do Do not Do not over not over over- - - torque. torque. Tightening the bolts too tight torque.
will damage the pump.
NOTE: NOTE: Always completely torque fluid covers before NOTE:
torquing fluid manifolds.
1. Remove the protective bolt covers (37) with
a screwdriver. Carefully work the screwdriver
under the lip of each cap and gently pry it off.
2. Start all fluid cover screws a few turns. Then, turn
down each screw just until head contacts cover.
Fluid Cover Fluid Fluid Cover Cover Screws Screws Screws
334794F
Tel: 866-777-6060
Fax: 866-777-6383
NOTICE NOTICE NOTICE
Springer Pumps, LLC
3. Turn each screw by 1/2 turn or less working in a
crisscross pattern to specified torque.
4. Repeat for fluid manifolds.
Assembly
Torque
Fluid Covers 60 in-lb (6.8
N∙m)
Fluid 40 in-lb (4.5
Manifolds N∙m)
Fluid Fluid Manifold Fluid Manifold Manifold Screws Screws Screws
Website: www.springerpumps.com
Torque Instructions
Re-Torque
55 in-lb (6.2
N∙m)
35 in-lb (4.0
N∙m)
23
Int'l: +001 267 404 2910