Mount The Pump - Graco ChemSafe 515 PT Instructions-Parts List Manual

Mount Mount The Mount The Pump The Pump Pump
To avoid serious injury from toxic fluid or fumes:
• Ventilate to a remote area. The pump
exhaust air may contain contaminants. See
Air Exhaust Ventilation, page
• Never move or lift a pump under pressure. If dropped,
the fluid section may rupture. Always follow the
Pressure Relief Procedure, page
or lifting the pump.
• Prolonged exposure to UV radiation will degrade
natural polypropylene components of the pumps. To
prevent potential injury or equipment damage, do
not expose pump or the plastic components to direct
sunlight for prolonged periods.
Accessories/Components Accessories/Components Not Accessories/Components
A Air supply line
B Bleed-type master air valve (required for
your pump)
C Air filter/regulator assembly
D Master air valve (to isolate the filter/regulator
for service)
E Grounded flexible fluid supply line
F Fluid drain valve (required for your pump)
G Fluid shutoff valve
H Grounded, flexible fluid outlet line
334794F
Tel: 866-777-6060
Fax: 866-777-6383
11.
14, before moving
Not Supplied Not Supplied Supplied
Springer Pumps, LLC
1. Be sure the mounting surface can support the
weight of the pump, hoses, and accessories, as
well as the stress caused during operation.
2. For all mountings, be sure the pump is secured
with screws through the mounting feet. Always
mount the pump upright.
3. Make sure the surface is flat and that the pump
doesn't wobble.
4. For ease of operation and service, mount the
pump so air valve, air inlet, fluid inlet and fluid
outlet ports are easily accessible.
System System Components System Components Components
J
Air inlet port (not visible)
K Exhaust port and muffler
L Fluid inlet port
M Fluid outlet port
N Mounting feet
Website: www.springerpumps.com
Installation
9
Int'l: +001 267 404 2910