Torque Instructions - Graco ChemSafe 307 Instructions-Parts List Manual

Torque Instructions

Torque Torque Torque Instructions Instructions Instructions
If fluid cover or manifold bolts have been loosened,
it is important to torque them using the following
procedure to improve sealing.
Do Do not Do not over not over- - - torque. over torque. torque. Tightening the bolts too tight
will damage the pump.
NOTE: Always completely torque fluid covers before
NOTE: NOTE:
torquing fluid manifolds.
1. Remove the protective bolt covers (37) with
a screwdriver. Carefully work the screwdriver
under the lip of each cap and gently pry it off.
2. Start all fluid cover screws a few turns. Then, turn
down each screw just until head contacts cover.
Fluid Cover Cover Screws Screws
Fluid Fluid Cover Screws
22
Springer Pumps, LLC
Telford, PA 18969
NOTICE NOTICE NOTICE
Tel: 866-777-6060 / Int'l: 215-949-2900
Fax: 866-777-6383 / Int'l: 215-721-1296
3. Turn each screw by 1/2 turn or less working in a
crisscross pattern to specified torque.
4. Repeat for fluid manifolds.
Assembly
Torque
Fluid Covers 20 in-lb (2.3
N∙m)
Fluid 15 in-lb (1.7
Manifolds N∙m)
Fluid Manifold Manifold Screws Screws
Fluid Fluid Manifold Screws
Re-Torque
15 in-lb (1.7
N∙m)
10 in-lb (1.1
N∙m)
334793B
shop.springerpumps.com
info@springerpumps.com