Torque Instructions - Graco 2200 Repair Parts

Torque Instructions

Torque Instructions Instructions
Torque Torque Instructions
If fluid cover or manifold fasteners have been
loosened, it is important to torque them using the
following procedure to improve sealing.
NOTE: Fluid cover and manifold fasteners have a
NOTE: NOTE:
thread-locking adhesive patch applied to the threads.
If this patch is excessively worn, the fasteners may
loosen during operation. Replace screws with new
ones or apply medium-strength (blue) Loctite or
equivalent to the threads.
NOTE: NOTE: Always completely torque fluid covers before NOTE:
torquing manifolds.
1. Start all fluid cover screws a few turns. Then, turn
down each screw just until head contacts cover.
2. Turn each screw by 1/2 turn or less working in a
crisscross pattern to specified torque.
3. Repeat for manifolds.
Fluid cover cover and and manifold manifold fasteners:
Fluid Fluid cover and manifold
in-lb (21 to 25 N•m)
4. Retorque the air valve fasteners in a crisscross
pattern to the specified torque.
Air valve Air Air valve fasteners: valve fasteners: fasteners: 45 to 55 in-lb (5 to 6 N•m)
5. Retorque the pilot valves to the specified torque.
Do not not overtorque. overtorque.
Do Do not overtorque.
Pilot Pilot valves: Pilot valves: valves: 20 to 25 in-lb (2 to 3 N•m)
Fluid Fluid Cover Fluid Cover Screws Cover Screws Screws
18
fasteners: 190 to 220
fasteners:
Inlet and and Outlet Outlet Manifold Manifold Screws
Inlet Inlet and Outlet Manifold
Air Valve Air Air Valve Valve Screws Screws and Screws and Pilot and Pilot Valves Pilot
Screws
Screws
Valves Valves
3A2714J